Follow these instructions to setup the Striven software on the Nippon PDT1100 unit

Step	Action
	Ensure Power is turned off on the Nippondenso. Hold Down 'SFT' + '0' + 'M1' + 'PWR' keys, it will come up with the selection 1: All 2: Drive A 3: Drive B Choose '1: All', It will come up with 'Initialize (Drive A)' - Select 'Yes'
	The unit will then Unit will power off.
	Power on the unit, by pressing the 'SFT' + '1' + 'PWR' keys.
	The Following menu will appear SYSTEM MENU 1:Exec Program 2:Download 3:Upload 4:Set System 5:Test6:Ver Choose option '4: Set System' and press the 'ENT' key.
	The following menu will appear SET SYSTEM 1:Program6:Com 2:Display7:Key 3:Date/Time 4:Barcode 5:Resume Choose option '6: Com' and press the 'ENT' key.
	The following menu will appear SET COM 1:Optical 2:Connector 3:Com Port 4:Protocol Type Choose Option '3: Com Port', and press the 'ENT' key.
	The following menu will appear SET COM PORT 1: BASIC OPTIFC 2: SYSTEM MODE OPTIFC Both these need to be set to IFC, to do this follow these instructions: Press '1', 'F8' and then '2', 'F8'. This will set both com port types to IFC, then press the 'ENT' key. Press 'C' key two times to return to the System Menu
	Then choose '2: Download' then press the 'ENT' key.
	Select '1. Drive A' then press the 'ENT' key.
	The Nippondenso will now be waiting for the computer to download the software.
	*If running 64-bit Windows* you will need to do the following: Open the following directory: S:\WE\Share\Programs\BCUtilities Run "Tsr-tu3a.exe", click Config and this menu will appear: Change PORT to the COM Port the NIPPON is connected to. Change Parity to NONE Set Baud to 19200 Change 'D' to 8 Change 'T' to 1 Click SEND, and select the following file/path: S:\WE\Share\Programs\BCUtilities\Software\RBI.pd3
	Otherwise, if running 32-bit Windows you will need to do the following: On your computer, click on Start, Run. Type in S:\WE\Share\Programs\BCUtilities\Software\LoadNippon.bat <COMPORT> Where <COMPORT> is the Com Port number where the Nippon is plugged in. So if it was on COM 1, then type in S:\WE\Share\Programs\BCUtilities\Software\LoadNippon.bat 1 And press Enter or click OK.
	Your Nippon should start counting; once it has finished, turn your Nippon off.
	Power on the unit, by pressing the 'SFT' + '1' + 'PWR' keys to access the menus.
	Then choose 1 to execute, and then choose the 2 user program for drive A.
	From the list of available program please select the RBI.PD3.
	When the software loads up, press 10: SETUP, 5: SET BAUD RATE, 5: 19200 Press OK.

Browser not supported